Skip to content

Subaru Diagnostic System (SDS) Interface Device – Denso DST-010

In 2022 Subaru introduced new Denso DST Interface. Denso DST-010 is the next Subaru-supported interface used with Subaru SSM4 and SSM5 diagnostic programming software. The DST-010 has new capabilities, and the internal 32-bit microcomputer is powerful to support protocol ISO9141(K/L) and HS-CAN and Subaru protocols. In addition, the built-in wireless module allows Wi-Fi and Bluetooth connection to a PC.

Subari-Denso-DST-010-interface-diagnoex

The interface, looking similar to a Chrysler Micropod (Mopar MDP), is equipped with a faster WiFi connection. Denso DST 010 does not have oscilloscope function. Master technicians who require an oscilloscope function may obtain an alternative. PicoScope makes good automotive oscilloscopes. 

DENSO DST AND MOPAR MDP
MOPAR MDP DENSO DST MICROPOD
The Denso DST-010 interface comes with a USB2.0 Mini-DIN connector and bracket to hold the USB cable and prevent accidental disconnection. In addition, the new Denso DST-010 eliminates the need for a separate DLC cable, as it plugs directly into the OBD port on the vehicle.
Denso DST-010
The DENSO DST-i may still be needed for specific functions, such as use with the PC-embedded oscilloscope, or for communication where SSM III is required.

Previous Post Next Post

Leave A Comment

Please note, comments need to be approved before they are published.

Welcome to our store
Welcome to our store
Welcome to our store