How to program a ABS Module on Ford F-650 / F-750 with 6.7 Liter Cummins Diesel Motor medium duty truck.
This vehicle is equipped with Techograph Equipped or Allison MD Transmission. Let's see how to program this ABS Module.
Connect the Ford VCM II or VCM3 Interface on the F650 or F750 truck, open Ford IDS software and scan the truck
Programmable Module Installation (PMI)
PMI is a scan tool process that configures settings in a new module. Data used for the PMI process is automatically downloaded from the original module and stored when a scan tool session is started. If this data cannot be retrieved from the module being replaced, the scan tool may prompt for As-Built data entry or display a list of parameter values that need to be manually selected. Some modules are reprogrammed during PMI when a strategy/calibration update is available. To carry out PMI, refer to Module Configuration.
On Programming Section Select GEM module
Check Air Brake Pressure
Select Axel Ratio
Leave a comment
Comments will be approved before showing up.
Also in TECH GUIDE
Ford FDRS Flash Programming
How to Flash Programming with wiTECH 2
How to program a Nissan CVT Transmission
How to program a Nissan CVT Transmission? With the new transmission you received, there will be a CD included, keep that CD, that's the CD we are going to use in the programming stage. It has the IP Characteristics data file. TCM performs accurate gear ratio control by retrieving and storing data (characteristic value). TCM records the degradation level calculated from the vehicle driving status; it is necessary to erase the degradation level data recorded by the TCM.