Ford FDRS Flash Programming

Ford FDRS Flash Programming

April 03, 2019

How to Flash Programming with Ford FDRS

Flash programming using Ford FDRS software, connect the Ford VCM II interface to OBD II / DLC port in the car. Click Read from VIN and GO, Ford FDRS will start to identify the vehicle based on VIN and the installed components in the vehicle network.

In this document, we will explain how to do flash programming using FDRS. Once your vehicle's all set up to flash, don't forget to connect the external battery maintainer.  For this test, we have in our programming bay a 2016 S-Max / Galaxy.



Select the Tab Toolbox and select the ECU, PCM, TCM or related module to Program.

 

Programming will continue

 

You will see the progress bar.

 

End of programming.



Leave a comment

Comments will be approved before showing up.


Also in TECH GUIDE

How to Flash Programming with wiTECH 2
How to Flash Programming with wiTECH 2

March 24, 2019

Flash programming using wiTECH 2.0 and Micropod II, we are programming Dodge RAM 1500 PICKUP 5.7L HEMI, Technical Service Bulletin TSB shows need to program powertrain control module PCM and wireless control module WCM, once the programming completes, need to do a vehicle restore function to re-sync the network

Read More

How to program a Nissan CVT Transmission
How to program a Nissan CVT Transmission

March 23, 2019

How to program a Nissan CVT Transmission?  With the new transmission you received, there will be a CD included, keep that CD, that's the CD we are going to use in the programming stage. It has the IP Characteristics data file.  TCM performs accurate gear ratio control by retrieving and storing data (characteristic value). TCM records the degradation level calculated from the vehicle driving status; it is necessary to erase the degradation level data recorded by the TCM.

Read More