Techauthority Programming Flash Token
Chrysler, Dodge, Jeep introduces a new Flash Token for diagnosing and programming any ECU module. It provides unlimited module Flash access for the token attached VIN, for a period of 1 year. Using the new method to do flash programming on ECU modules, you must fulfill the following requirements,
- Active wiTECH 2.0 Software license. (Required to diagnose, flash and Restore Vehicle Configuration.)
- Active TechAuthority Software license. Required for flash, Secure Gateway (SGW) access, and Restore Vehicle Configuration.
- Vehicle Reprogramming Subscription (Flash Token).
wiTECH 2.0 and Techauthority both software subscriptions must be current and active, and the Vehicle Reprogramming Subscription (Flash Tokens) must be purchased and in your account to complete any Flash programming.
The cost for the "Vehicle Reprogramming Subscription" (Flash Token) will now be $35 per VIN. This provides unlimited module Flash access for that VIN for a period of 1 year. If the same vehicle (VIN) is serviced again, that Flash will not require another Subscription (Token) until the 1 year time has passed since the first Flash.
The Vehicle Reprogramming Subscriptions (Flash Tokens) that are purchased are added to your account and will not start the access run-time until a VIN is read by the service tool during the first Flash attempt. We have been told that wiTECH 2.0 Diagnostic Application or the wiTECH 2.0 J2534 Application will check for an available and valid Vehicle Reprogramming Subscription (Flash Token) in your account and display the balance of available Subscriptions (Flash Tokens) inside of the wiTECH 2.0 software.
If you're attempting to Flash a used module, please be aware that you must perform the Flash in a specific order to successfully Flash a used module! If the correct programming sequence isn't followed, you may waste a Flash Token!
Leave a comment
Comments will be approved before showing up.
Also in RESOURCES
Hyundai GDS SMART
Hyundai GDS SMART by Hyundai Motor Group, the world is changing faster than ever, and technology is corresponding with rapid progress.
Subaru Diagnostic System (SDS) Interface Device – Denso DST-010
In 2022 Subaru introduced new Denso DST Interface. Denso DST-010 is the next Subaru-supported interface device for use with Subaru SSM4 and SSM5 diagnostic programming software.
NISSAN CONSULT New Changes - 2022
Version 224 released in November, Additional login will be required to open and use CONSULT software. Access cards (immobilizer, Leaf battery, GTR) will no longer have to be inserted into your CONSULT PC.User login credentials will determine you access rights for immobilizer, Leaf battery and GTR functionality.